Jump to content


Photo

Nizo 801 service manual


  • Please log in to reply
2 replies to this topic

#1 Jacek Zagaja

Jacek Zagaja
  • Basic Members
  • PipPipPip
  • 101 posts
  • Other
  • Szczecin

Posted 22 March 2018 - 03:37 PM

Looking for SM if exists. Main motor does not work, only zoom motor and solenoid.

IMG_9246.JPG
  • 0

#2 Martin Baumgarten

Martin Baumgarten
  • Basic Members
  • PipPipPip
  • 205 posts
  • Industry Rep
  • Plattsburgh, New York U.S.A.

Posted 22 March 2018 - 04:41 PM

The drive motor rarely goes bad on these cameras. Have you tried to run a power supply directly to the motor alone and test that?  Usually the issue has to do with power leaving the variable speed control module.  So, first off I would recommend using a voltage meter and testing the current flow to and from that module.  If nothing comes out, then that's the issue.  Usually it's mild surface corrosion causing electrical resistance. Some spray contract cleaner for electronics might cure that.  Sometimes when the speed control fails, the camera will often default to the top run speed of 54fps.  IF it truly is the motor, you can use one from most any similar model, since they differ mostly by the lens setup...so finding another one which has other damage but the motor runs.  Anyhow, check all that out first, you might be fortunate and still have a running camera.  If the speed control module is bad, another can be used.  As for new parts, there might be some available from Germany, but even so those are very old now as well.  It's the capacitor that deteriorates, same as on speed control units for Super 8 projectors.  If you know how to test those, do so, and get a replacment from an electronics parts house online.

Good luck!

 

 

There is a schematic booklet on eBay for these cameras right now.  Here's the link:

https://www.ebay.com...xIAAOSwMQBZ~4~s


  • 0

#3 Jacek Zagaja

Jacek Zagaja
  • Basic Members
  • PipPipPip
  • 101 posts
  • Other
  • Szczecin

Posted 22 March 2018 - 04:47 PM

Motor and meter was working with linear power supply connected. I did LM317 for the meter and when assembled grip and connected 6x1,5V high current passed through and I could smell bad odour. Now only solenoid works. Do you know which wires for main motor?


  • 0


Metropolis Post

Broadcast Solutions Inc

The Slider

CineLab

Aerial Filmworks

FJS International, LLC

Tai Audio

Gamma Ray Digital Inc

rebotnix Technologies

Paralinx LLC

Ritter Battery

CineTape

Technodolly

Wooden Camera

Visual Products

Rig Wheels Passport

Willys Widgets

Media Blackout - Custom Cables and AKS

Abel Cine

Glidecam

rebotnix Technologies

Broadcast Solutions Inc

Media Blackout - Custom Cables and AKS

Technodolly

CineTape

Abel Cine

Aerial Filmworks

Visual Products

Paralinx LLC

Rig Wheels Passport

CineLab

Willys Widgets

Tai Audio

Glidecam

The Slider

Wooden Camera

Ritter Battery

Metropolis Post

FJS International, LLC

Gamma Ray Digital Inc